Selco Seal Gaskets Operating Parameters ANSI, DIN & JIS Standards Unlimited size, shape and saterial Fabricated to customers specifications Gaskets are unaffected by temperature, corrosive media or thermal cycling Design eliminates cold flow Sized for use in tongue and groove Available as a full face gasket or multibar heat exchanger Sealing element position can be adjusted if flange has a pitted or scared finish Specify metal type or use same or similar to flange pH RANGE with Graphoseal - 0 TO 14 (except strong oxidizers) Unlimited shelf life Installation Selco Seal is easy to install Fits ANSI pipe size and pressure range 150psi - 2,500 psi Works on all existing flanges 10 - 400 micro inches rms Can not be over compressed Torque to 50 - 65% of bolt yield No need to retorque Selco Seal is as leak proof as a weld - provides a permanent seal in severe conditions where normally only a weld will do Features Standard sealing elements width: Minimal sealing element web width: Minimum sealing pressure: Leak rate: 0.125" each side 0.200" <3,000 psi 1 x 10-7 scc/sec. <T3 - Exceeds EPA Standards Primary Features Temperature Range: -3280F (-2000C) ambient air to +9320F (+5000C) in atmosphere +1,2000F (+6500C) in steam +5,4320F (+3,0000C) reducing or inert media Pressure range: Minimum searing stress: Pressure capability: Fire Safe Blow-out proof Full vacuum to +5,000 psi <3,000 psi Tested to 5,000 psi, internal pressure Main Selco Seal Page Operating Parameters Selco Style 1530 Selco Style 1530 PTFE / 1530 PTFE and Flexible Graphite